• If ordered, the Principal Rake Pack guardrail for stairs is provided on a plot specific basis, cut to exact
• dimension and pitch to suit each individual stair – see note above on compliance.
• The system offers initial Health & Safety benefits where a defined system is not in place.
• The Temporary Guardrail offers additional rigidity to flights during 1st fix until the preassembled balustrade is fitted.
• The system uses our tested Quick-Fix interlocking brackets, so simple and convenient to fit on site reducing damage to newel posts.
• Fixing instructions and checking procedures are included upon delivery.

• The system can be re-used, however it is essential that the site management team  inspect the handrail regularly to ensure it is correctly fitted and not damaged.
• If the full Staircraft Temporary Edge Protection system is not purchased, we will assume that alternative means of fall protections have been employed on site.
• Health & Safety on site remains the responsibility of the builder and individual and Staircraft will not accept liability.
• Full test details are available upon request.
• To assist with site installation of this system, a Step-by-Step Guide, is included in this pack and will be supplied with the product.

Step 1

When principal rake rails are supplied they are cut to length with clip connectors attached.

Step 2

Insert principal rake rail into correct position locating the clips at top and bottom.

Step 3

Using batten strike down until rail is fully locked in position.

Step 4

Position suspending steel brackets 250mm from each newel post and fix through pre-drilled holes using 4 x 40mm screws.

Step 5

Cut intermediate rail to length leaving a minimum of 80mm overlap of the newel at both ends.

Step 6

Fix intermediate rail into bracketsusing 4 x 40mm screws. Important – please ensure the minimum 80mm overlap of the newel is positioned on the side shown above.

Step 7

Fix balcony post into universal post bracket and fix at each end of opening.

Step 8

Cut principal balcony rail to length and re-affix locking clip.

Step 9

Insert balcony rail between posts on locking clips ensuring it is locked in place.

Step 10

Position suspending steel brackets 250mm from each newel post and fix through pre-drilled holes using 4 x 40mm screws.

Step 11

Cut intermediate rail to length leaving a minimum of 80mm overlap of the newel at both ends.

Step 12

Fix intermediate rail into brackets using 4 x 40mm screws. Important - please ensure the minimum 80mm overlap of the newel is positioned on the side shown above.